stm32flash-0.7-bp160.1.12 RPM for s390x

From OpenSuSE Leap 16.0 for s390x

Open source flash program for the STM32 ARM processors using the ST
serial bootloader over UART or I2C.

Features:
- UART and I2C transports supported
- device identification
- write to flash/ram
- read from flash/ram
- auto-detect Intel HEX or raw binary input format with option to force
  binary
- flash from binary file
- save flash to binary file
- verify & retry up to N times on failed writes
- start execution at specified address
- software reset the device when finished if -R is specified
- resume already initialized connection (for when reset fails, UART only)
- GPIO signalling to enter bootloader mode (hardware dependent)

Provides

• stm32flash
• stm32flash(s390-64)

Requires

• libc.so.6()(64bit)
• libc.so.6(GLIBC_2.2)(64bit)
• libc.so.6(GLIBC_2.3)(64bit)
• libc.so.6(GLIBC_2.3.4)(64bit)
• libc.so.6(GLIBC_2.33)(64bit)
• libc.so.6(GLIBC_2.34)(64bit)
• libc.so.6(GLIBC_2.4)(64bit)
• libc.so.6(GLIBC_2.7)(64bit)
• rpmlib(CompressedFileNames) <= 3.0.4-1
• rpmlib(FileDigests) <=